OZ9AEC

A few closeup photos showing the eCAM32 3.2 megapixel camera mounted on top of the Gumstix Overo Water, mounted on the Tobi expansion board.

As promised in my last post, here is a quick demo of the eCAM32 3.2 megapixel camera connected to the Gumstix Overo Water. I am presenting two videos, one showing the setup where the eCAM32 camera board is mounted on top of the Gumstix Overo Water, the other one being a screen cast demonstrating some of the most common settings of the camera. I am using the Tobi expansion board because it has Ethernet interface allowing me to stream H.264 encoded video to a host PC running linux.

Two recordings I made during the 2011 CQ WW CW contest showing how well the Butternut HF2V receives on the 21 and 28 MHz bands. The videos were recorded using the Funcube Dongle equipped with the HF converter kit and my GNU Radio based software defined radio receiver, GQRX.

I usually check my Butternut HF2V vertical antenna every spring to see how much it has suffered during the winter. The winters in Denmark can be very windy and wet, which is not very good for an antenna. This spring I was rather busy and I postponed the annual check until now. I haven't used the antenna for a long time, so I didn't know what to expect. Physically, the antenna is still standing and only one of the four guy ropes needed to be repaired since the last check more than 1.5 year ago.

As I mentioned in my previous post, I had only had limited success with the Caspa VL and Logitech UVC cameras. While both cameras work with the Gumstix, the Caspa seems to take poor images while the Logitech USB camera performance is limited by low USB bandwidth. Therefore, I have decided to try my luck with cameras from e-Con Systems.