Elecraft T1 Automatic Antenna Tuner

The Elecraft T1 is a stand-alone, miniature antenna tuner unit specially designed for use with low-power HF/6m transceivers. Despite its small size, it uses a built in 9V battery, provides a wide matching range and can handle powers up to 20 watts SSB/CW or 10 watts in FM/AM/digi. It is a very cool general-purpose ATU for mobile and portable use. The T1 is available either ready built or as a kit.

Read more

FT-817 Remote Cable for the T1

Tonight I have tried to use the FT-817 remote cable that I bought together with the T1. First, I wanted to find the leaked RF info signals sent by the T1. According to the manual, there should be at least one signal on every ham band and I found one around 7024 kHz.

Read more

T1 Preliminary Tests

I have now done som basic tests of the T1. I decided to tune the MP-1 to somewhere in the 40 meter band and then try to match it with the T1 on the other bands. The initial setting of the MP1 was as follows:

Read more

T1 Smoke Tests

I have just completed the assembly of the T1. The power on tests from the assembly manual are all all right. I must wait with the functional tests till I am back in LMX, because I have no 50 ohm calbes here.

Read more

T1 Control Board

I have now finished the control board as well. All resistance checks passed. I can not do the LED test, because I do not have the diode tester here, it’s in LMX. In any case, I have been very careful when mounting the LEDs, so they should be all right.

Read more

Coils for the T1

I have now finished the last two coils, L6 and L7, as well. Looking back I think it was a very good idea to make the coils in the same order as described in the assembly manual: L1 … L7. It starts with just a few turns and increases gradually up to 29 turns on L7.

Read more

T1 Main Board

So, I have spent most of the time since saturday noon on building the T1. I have made good progress so far; I finished almost everything on the main board except the last two coils, L6 and L7.

Read more